Sony DFS-900M - Communications Protocol Settings; Baud Rate Settings; Parity Bit Settings

162
Serial Interface Settings
Chapter 7 External Control Interface Settings
Communications Protocol Settings
Adjust the following parameters in the Protocol sub menu
to specify the communications protocol.
a) For each parameter, rotate the corresponding knob to select the serial
communications device to be connected. Select “---” if you do not want to
select a device.
Baud Rate Settings
Adjust the following parameters in the Baudrate sub menu
to set the baud rate.
Parity Bit Settings
Adjust the following parameters in the Parity sub menu to
set the parity bit.
Knob Parameter Description Settings
a)
F1 1 RS-422A, port 1 Specify the serial
communications
device to be
connected from
among the following:
GVG100, BVS3000,
HVS-AUX
F2 2 RS-422A, port 2 GVG100, BVS3000,
HVS-AUX
F3 3 RS-422A, port 3 GVG100, BVS3000,
HVS-AUX
F4 4 RS-422A, port 4
(editor)
GVG100, BVS3000,
HVS-AUX
Knob Parameter Description Settings
F1 1 RS-422A, port 1 9600, 19200, 38400
F2 2 RS-422A, port 2 9600, 19200, 38400
F3 3 RS-422A, port 3 9600, 19200, 38400
F4 4 RS-422A, port 4
(editor)
9600, 19200, 38400
Knob Parameter Description Settings
F1 1 RS-422A,
port 1
None: Do not use a
parity bit
Odd: Odd parity
Even: Even parity
F2 2 RS-422A,
port 2
None: Do not use a
parity bit
Odd: Odd parity
Even: Even parity
F3 3 RS-422A,
port 3
None: Do not use a
parity bit
Odd: Odd parity
Even: Even parity
F4 4 RS-422A,
port 4
(editor)
None: Do not use a
parity bit
Odd: Odd parity
Even: Even parity
Knob Parameter Description Settings