Sony DFS-900M - Chapter 7 External Control Interface Settings; Serial Interface Settings

161
Serial Interface Settings
Chapter
Chapter 7 External Control Interface Settings
7
External Control
Interface Settings
Serial Interface Settings
Before connecting an editor or AUX bus remote controller,
you must set up the serial interface by making
communication settings.
To make communication settings, use the Serial sub menu
of the Setup menu. The Serial sub menu has the following
sub menus.
To show the sub menus
In the External Connections and Power block, press the
EDITOR button twice in quick succession.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the h and H
buttons in the numeric keypad.
Always make the communication settings in these sub
menus before connecting a serial communications device.
Sub menu Operation
Protocol Set the communication protocol
Baudrate Set the baud rate
Parity Set the parity bit
Note
EDITOR button
BKDF-901
BKDF-902
EDITOR button