174
System Settings
Chapter 9 3D Mode
System Settings
1
When using the BKDF-901: If the SHIFT button in
the DME/SETUP block is not lit, press it to light it.
When using the BKDF-902: Skip to step
2
.
2
Press the SYSTEM button.
The most recently used sub menu appears in the
display panel.
3
Press the < or > button in the numeric keypad until the
3D SYSTEM sub menu appears.
Switching to 3D Mode
Set the following parameters with knob 1.
Selecting the 2D/3D Mode of Stored
Still Images
When the switcher is operating in 3D mode, you can use
images stored in still image memory in either 2D or 3D
mode.
Select the mode by setting the following parameters with
knobs 2 and 3.
When you select 2D, the same signal is used for left and
right.
When you select 3D, separate signals are used for left and
right.
Signal Assignments for Using Still Images
in 3D Mode
When you set the still image mode to 3D, the signal
assignments of the cross-point buttons (see the table shown
on the previous page) are changed.
When using the BKDF-901
When you select 3D with the F2 knob or F3 knob, the
signal assignments of cross-point buttons 9 and 10 or 11
and 12 are changed as follows.
When using the BKDF-902
When you select 3D with the F2 knob or F3 knob, the
signal assignments of cross-point buttons 13 and 14 or 15
and 16 are changed as follows.
Knob Parameter Description Settings
F1 3D Mode Operate in 3D
mode
On, Off
Knob Parameter Description Settings
F2 3D Stll1 & Still2 Stil1 image mode 2D, 3D
F3 3D Stll3 & Still4 Stil2 image mode 2D, 3D
Cross-point buttons Video signals
Left Right
9 STL1 STL2
10 STL2 STL1
11 STL3 STL4
12 STL4 STL3
Cross-point buttons Video signals
Left Right
13 STL1 STL2
14 STL2 STL1
15 STL3 STL4
16 STL4 STL3
To Next Page
Loading...
