175
3D Mode Operations
Chapter 9 3D Mode
3D Mode Operations
The following limitations apply to operations in 3D mode.
• The available transition types are limited to cut and mix
by button operations.
• When an operation on a DSK is performed, M/E keys
behave in the same way.
You cannot directly operate M/E keys.
The DSK1 and DSK2 values set in the menu are applied
to KEY1 and KEY2, respectively.
• Events created in 3D mode can be used only in 3D mode.
• Sequence functions are not available.
• A function which captures still images from input
signals is available only for the left signals.
When using the BKDF-901
Some buttons are not available (the buttons shown in black
in the following figure).
When using the BKDF-902
Instead of operating with the M/E Cross-Point Bus block
and the M/E Transition block, use the PROGRAM/
PRESET Cross-Point Bus block and the PROGRAM/
PRESET Transition block.
Some buttons are not available (the buttons shown in black
in the following figure).
Operating block Unavailable buttons
KEYER block DME ENBL, CK, MASK
EDGE SHADOW
(EXT and SELF are disabled for
KEY1 and KEY2.)
KEY DELEGATION block KEY3, KEY4
Transition block TRANS PVW, KEY1 to KEY4
WIPE (FAM), DME (NAM)
PRIORITY, FTB
BKDF-901
Operating block Unavailable buttons
KEYER block DME ENBL, CK, MASK
EDGE SHADOW
(EXT and SELF are disabled for
KEY1 and KEY2.)
KEY DELEGATION
block
KEY3, KEY4
M/E rows All buttons and the fader lever
PROGRAM/PRESET
Cross-Point Bus block
M/E buttons
KEY DELEGATION
block
KEY3, KEY4
DSK/Fade to Black
Control block
FTB
BKDF-902
To Next Page
Loading...
