169
Updating the System
Chapter 8 Other Operations and Settings
If there is not enough free memory on the USB flash drive,
the backup is cancelled and an error message appears.
To recall backup file data from a USB flash drive
Connect a USB flash that contains backup file data and
then proceed as follows.
1
Rotate the F3 knob to select the type of file data.
Stl: Data saved as still image files
Seq: Data saved as sequence files
Usr: User pattern data
2
Press the F2 knob and hold it down for one second or
longer.
To clear file data from a USB flash drive or control
panel memory
1
Rotate the F3 knob to select the type of file data.
Stl: Data saved as still image files
Seq: Data saved as sequence files
Usr: User pattern data
2
Rotate the F4 knob to select the memory that you want
to clear.
USB: USB flash drive connected to the USB
MEMORY connector
CP: Memory of the switcher’s control panel
3
Press the F4 knob and hold it down for one second or
longer.
Updating the System
Use the Update sub menu of the Setup menu to update the
system software, and to turn the display panel cursor icon
on or off.
To display the Update sub menu
1
When using the BKDF-901: If the SHIFT button in
the DME/SETUP block is not lit, press it to light
it.
When using the BKDF-902: Skip to step 2.
2
Press the SYSTEM button.
The most recently used sub menu appears in the
display panel.
3
Press the h and H buttons in the numeric keypad
until the Update sub menu appears.
Note
BKDF-901
BKDF-902
To Next Page
Loading...
