46
Installing Optional Expansion Boards
Chapter 3 Preparations
9
Using the four screws removed in step 1, attach the board tray stabilizers.
To remove I/O expansion boards
Carry out the installation procedure in reverse.
Installing Function Expansion Boards
About installation locations
Pull the standard I/O module out from the rear panel of the processor unit, and
install the function expansion boards on the standard I/O module. Insert the
expansion board connectors into the sockets on the standard I/O module and
secure them with the screws supplied with the expansion boards. Connect the
BKDF-940 to the DME1 and DME2 sockets, and connect the BKDF-950 to the
MV1 and MV2 sockets.
Yes: Can be installed No: Cannot be installed
Function
expansion
board
Socket on standard I/O module
DME1 socket DME2 socket MV1 socket MV2 socket
BKDF-940 2CH
DME Board
Ye s Ye s N o N o
BKDF-950 Multi
Viewer Board
No No Yes Yes
To Next Page
Loading...
