45
Installing Optional Expansion Boards
Chapter 3 Preparations
For the BKDF-912 and BKDF-962, use a nut driver to tighten the hexagon
head bolt.
2Using the two screws removed in step 3, secure the connector name plate
to the expansion board installation tray.
Set the tightening torque to 0.49 N·m for step 6-2.
7
Insert the expansion board installation tray into its original slot, and align
the notches of the levers on both sides of the tray to the left and right sides
of the slot mouth.
8
As shown in the figure below, lock the tray by pulling the tray levers toward
the inside.
The tray is pushed all the way into the slot and locked in place.
Expansion board Screws Tightening torque
BKDF-910
BKDF-911
BKDF-960
BKDF-961
+M2.6 × 4 0.49N·m
BKDF-912
BKDF-962
Hexagon head bolt
(5mm in width across flats) × 4
0.5N·m
Note
Note
(For BKDF-910)
To Next Page
Loading...
