44
Installing Optional Expansion Boards
Chapter 3 Preparations
5
Push the connectors of the expansion board through the inner side of the
connector name plate frame, place the expansion board on the expansion
board installation tray, and secure the board with the supplied four +M3
screws.
• Use a torque screwdriver to tighten the screws. Set the tightening torque
to 0.59 N·m.
• For the installation positions of expansion boards, see page 39.
6
Use the following procedure to attach the connector name plate supplied
with the expansion board.
1Using the screws (see the following table) supplied with the expansion
board, secure the connector name plate to the expansion board.
Notes
(For input expansion boards)
(For output expansion boards)
3Remove the adhesive surface cover sheet from the top side of the
heat transfer sheet.
To Next Page
Loading...
