43
Installing Optional Expansion Boards
Chapter 3 Preparations
4
Use the following procedure to affix the heat transfer sheet (supplied with
each I/O expansion board) to the expansion board installation tray.
1Remove the adhesive surface cover sheet from one side only of the
heat transfer sheet.
2Hold the bottom side of the heat transfer sheet (the side from which
you removed the adhesive cover sheet) down and affix it to the
expansion board installation tray, aligning it with the positioning
guide frame on the expansion board installation tray.
I/O expansion board heat transfer sheet affixation position (shaded part)
BKDF-910
Positioning guide frames
(for input expansion board)
Positioning guide frame
(for output expansion board)
BKDF-911 and
BKDF-912
To Next Page
Loading...
