105
Basic Switcher Settings
Chapter 3 Preparations
This setting is ignored when the video format setting is 720/50 or 720/59
(see page 71).
Selecting the operating mode of the SHIFT buttons
Use the following procedure to select the operating mode of the SHIFT buttons
of the cross-point bus block.
1
When using the BKDF-901: If the SHIFT button of the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step 2.
2
Press the SYSTEM button.
A settings sub menu of the System sub menu appears in the display panel.
3
Press the h or H button in the numeric keypad until the Other sub menu
appears.
“Other” appears in the sub menu title display area. If it is already displayed
there, you can skip this step.
4
Rotate the F3 knob to select the timing of video switching.
Moment: Selects the SHIFT side functions assigned to buttons as long as a
SHIFT button is held down.
Toggle: Each press of a SHIFT button toggles between selecting the SHIFT
side and non-SHIFT side functions assigned to buttons.
Note
BKDF-901
BKDF-902
To Next Page
Loading...
Need help?
General
