Sony DFS-900M - Page 157

157
Sequence Operations
Chapter 6 Registering Operations and Settings
1 Press the SEQ button in the numeric keypad.
The numeric keypad enters sequence mode.
The most recently used sub menu appears in the
display panel.
2 Press the j and J buttons in the numeric keypad
until the Seq File sub menu appears.
3 Rotate the F3 knob to select the storage destination of
the sequence that you want to recall.
You can select either the switcher control panel (CP)
or a USB flash drive.
4 Rotate the F1 knob to select the file that contains the
sequence that you want to recall.
An asterisk (*) appears after the number of file that
contains a sequence.
5 Press the RECALL button.
The sequence in the selected file is recalled.
To display the video of the first keyframe
when a sequence is recalled
The normal procedure for recalling a sequence does not
recall the video of the first keyframe. If you want to display
the video of the first keyframe when a sequence is recalled,
proceed as follows.
1 Press the SEQ button in the numeric keypad.
The numeric keypad enters sequence mode.
The most recently used sub menu appears in the
display panel.
2 Press the j and J buttons in the numeric keypad
until the Seq Setup sub menu appears.
3 Rotate the F1 knob to specify whether to recall the first
keyframe.
Onl (Only Recall): Do not recall the first keyframe.
Rew (Recall+Rewind
): Recall the first keyframe.
To replace the current video settings with
the settings of a registered sequence
Before recalling the sequence, proceed as follows.
Tip
BKDF-901
BKDF-902
BKDF-901
BKDF-902