Sony DFS-900M - Page 20

20
BKDF-901 1M/E Control Panel
Chapter 2 Names and Functions of Parts
a EXT DISPLAY (external display) connector
(high-density D-sub 15-pin)
You can also connect an optional touch panel monitor.
b PROCESSOR connector (RJ-45)
Use the supplied control cable to connect to the PANEL
connector of the processor unit.
This connector is for connection to the DFS-900M
processor unit only. It cannot be connected to the processor
unit of any other system.
• When you connect the PROCESSOR connector of the
unit to peripheral devices, use a shielded-type cable to
prevent malfunction due to radiation noise.
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
Par mesure de sécurité, ne raccordez pas le connecteur
pour le câblage de périphériques pouvant avoir une tension
excessive à ce port. Suivez les instructions pour ce port.
Aus Sicherheitsgründen nicht mit einem
Peripheriegerät-Anschluss verbinden, der zu starke
Spannung für diese Buchse haben könnte. Folgen Sie den
Anweisungen für diese Buchse.
c MAINTENANCE connector (D-sub 9-pin)
Provided for inspection / maintenance. Not used for
operating this system.
d DEVICE connector (USB Type-A)
Allows you to connect an optional touch panel monitor or
a mouse.
e Ground terminal
Connect to the system ground wire.
f - AC IN connector
Connect to an AC power with an AC power cord (not
supplied).
g POWER switch
Powers the control panel on and off.
Note
CAUTION
ATTENTION
VORSICHT