49
Installing Optional Expansion Boards
Chapter 3 Preparations
4
Align the connectors of the function expansion board with the sockets on the
signal processing board of the standard I/O module, grasp the board near the
connector, and push the board down until the connector is coupled into the
socket.
For the installation location of each expansion board, see page 46.
5
Using the four +M3 screws supplied with the function expansion board,
secure the expansion board to the signal processing board of the standard
I/O module.
Use a torque screwdriver to tighten the screws. Set the tightening torque to
0.59 N·m.
3Remove the adhesive surface cover sheet from the top side of the heat
transfer sheet.
Note
Note
To Next Page
Loading...
