94
Basic Switcher Settings
Chapter 3 Preparations
a) Connector is disabled
5
If you selected Y/CB/CR in step 4, rotate the F4 knob to select the level of
the component output signals.
Betacam: Betacam level
SMPTE: SMPTE level
Settings of step 5 can be available only when the switcher’s video format
(see page 71) is set to 525/59, 720/59, or 1080/59.
Specifying the signal type of DVI output signals
When you are using the optional BKDF-962 2 DVI Output Board, specify the
signal type of the DVI signals that will be output from the board.
For more information about the BKDF-962, see page 31. For information about
how to install it, see page 39.
Setting of
step 4
Name of
BKDF-961
connector
Output signal BKDF-961 installation
position and channel
number
Lower tray Upper tray
Left Left
Compst COMP/Y Composite signal AUX03 AUX07
B-Y
a)
–––
R-Y
a)
–––
COMP Composite signal AUX04 AUX08
Y-CB/CR COMP/Y Y (luminance) signal AUX03 AUX07
B-Y Color difference
(B-Y) signal
R-Y Color difference
(R-Y) signal
COMP Composite signal AUX04 AUX08
GBR/wSync COMP/Y G (green) signal (with
multiplexed sync
signal)
AUX03 AUX07
B-Y B (blue) signal
R-Y R (red) signal
COMP Composite signal AUX04 AUX08
Note
To Next Page
Loading...
