6-19
DSC-F828
10. Light Value Adjustment
Adjust the standard LV value.
Mode STILL (P AUTO) (P)
Subject Clear chart (PTB-1450/PTB-450)
(Standard picture frame)
Measurement Point Data of page: 10, address: 0C, 0D
Measuring Instrument Data of page: 6F, address: 65
Adjustment Page 6F
Adjustment Address 65 to 67
Specified value1 0FE0 to 1020
Specified value2 40 to 60
Note1: If the data of page: 60, address: 02 is “01”, select page: 60, address:
01, and set data: 00.
Switch setting:
ZOOM.................................................................... WIDE end
Adjusting method:
Order Page
Address
Data Procedure
1 Check that “1. Data Setting
during Camera System
Adjustments” is performed.
2 Check the picture frame. If
deviated, perform “5. or 6.
Picture Frame Setting”.
3 60 01 0D Set the data.
4 Wait for 2 sec.
5 60 02 Read the data, and check it is
“01”. (Note2)
6 10 0C Read the data, and this data is
named D0C.
7 10 0D Read the data, and this data is
named D0D.
8 Calculate DLV using the
following equation
(Hexadecimal calculation)
DLV = D0C × 100 + D0D
10 Check that DLV satisfies the
specified value1.
11 6F 65 Read the data, and check it
satisfies the specified value2.
Note2: The adjustment data will be automatically input to page: 6F,
address: 65 to 67.
Processing after Completing Adjustments:
Order Page
Address
Data Procedure
1 60 01 00 Set the data.
2 If finish the camera system
adjustments, release the data
setting.
(See “1. Data Setting during
Camera System Adjustments”.)
To Next Page
Loading...
