Sony DSC-F828 - 1-6. LCD System Adjustment

6-35
DSC-F828
1-6. LCD SYSTEM ADJUSTMENT
Note1: When replacing the LCD unit, be careful to prevent damages
caused by static electricity.
Note2: If you perform the adjustments with FINDER/LCD switch (Control
switch block (UNDER)) removed, set the following data.
1) Select page: 80, address: 10, and set data: 1A.
2) Select page: 80, address: 11, and set data: 00.
Reset the data after completing adjustment.
1) Select page: 80, address: 10, and set data: FF.
2) Select page: 80, address: 11, and set data: 00.
Switch setting:
FINDER/LCD ................................................................. LCD
1. Data Setting during LCD System Adjustments
Perform the following data setting before the LCD system
adjustments.
Note1: When the power is turned off, some data settings will be released.
So perform this data setting again when the power is turned off.
Order Page Address Data Procedure
1 00 01 01 Set the data.
2 80 70 01 Set the data.
After completing the LCD system adjustments, release the data
setting.
Order Page Address Data Procedure
1 80 70 00 Set the data.
2 Save the data.
3 Wait for 2 sec.
4 00 01 00 Set the data.
2. LCD Initial Data Input
Mode PLAY ( )
Signal Arbitrary
Adjustment Page 8F
Adjustment Address 20, 21, 23 to 28, 2A, 2C
Adjusting method:
1) Select page: 00, address: 01, and set data: 01.
2) Select page: 8F, and write the data in the following table.
3) Save the data.
4) Wait for 2sec.
5) Select page: 00, address: 01, and set data: 00.
Address
20
21
23
24
25
26
27
28
2A
2C
Remark
Fixed data
Fixed data
VCO adj.
VCOM adj.
Fixed data
Fixed data
Fixed data
White balance adj.
White balance adj.
Contrast adj.
A5
19
80
76
84
00
63
90
80
72
Data