6-29
DSC-F828
18. AF Laser Output Adjustment
Adjust the AF laser output power.
Mode STILL (P AUTO) (P)
Subject Background paper (J-2501-130-A).
(50cm from the front of the lens)
Measurement Point Data of page 6F, address: 13
Measuring Instrument
Adjustment Page 6F
Adjustment Address 10 to 16
Specified Value 00
Note1: Perform this adjustment in the dark room or use the flash
adjustment box.
Note2: Any light other than the strobe light should not light up the plate.
Switch setting:
ZOOM.................................................................... WIDE end
Adjusting method:
Order Page
Address
Data Procedure
1 Check that “1. Data Setting
during Camera System
Adjustments” is performed.
2 6F 10 20 Set the data.
3 6F 15 48 Set the data.
4 60 01 AF Write the data.
5 Check that the AF laser is lit.
6 Wait for 8 sec.
7 60 02 Read the data, and check it is
“01”. (Note3)
8 6F 13 Read the data, and check it
satisfies the specified value 1.
Note3: The adjustment data will be automatically input to page: 6F,
address: 10 to 16.
Processing after Completing Adjustments:
Order Page
Address
Data Procedure
1 60 01 00 Write the data.
2 If finish the camera system
adjustments, release the data
setting.
(See “1. Data Setting during
Camera System Adjustments”.)
To Next Page
Loading...
