4-31
DSR-80/80P/60/60P
[SAVE/LOAD|CONTROL]
The respective items of “SAVE/LOAD CONTROL” are described
below.
(1) SAVE ADJUSTING DATA
Saves the adjustment data to EEPROM.
Confirm that “COMPLETE” appears after completing saving data.
Note : Be sure to save data using this mode after completing
adjustment.
(2) LOAD ADJUSTING DATA
Loads the adjustment data from EEPROM.
Confirm that “COMPLETE” appears after completing loading
data.
(3) INITIALIZE
Use INITIALIZE only when the MS-43 board or the IC1 on either
MS-43 board is replaced.
Loads the initial data of the adjustment data from ROM.
Confirm that “COMPLETE” appears after completing
initialization.
To Next Page
