3-8
DSR-80/80P/60/60P
Detection : Checks that switch S101, S201 on the
SV-184 board is set to ON.
Operation after detection : None
Display : The alarm is displayed until any key is
pressed.
Detection : Checks that the FACTORY USE item
of the Setup menu is changed.
Operation after detection : None
Display : The alarm is displayed until any key is
pressed.
ALARM
THE UNIT IS IN
ADJUSTMENT MODE.
SET THE SWITCHES OF
S101 AND S201 ON THE
SV BOARD TO OFF.
ALARM
SELECTIONS OF THE SETUP
MENU’S FACTORY USE
ITEMS HAVE BEEN CHANGED.
SET THESE ITEMS TO
FACTORY PRESET VALUES.
To Next Page
