WARNING
Welcome!
To prevent fire or shock
hazard, do not expose the
unit to rain or moisture,
To avoid electrical shock,
do not open the cabinet. _gg_Lm_er _spa_e Provided behi_v'
Refer tot_'_ w_en_L_ call upon !
Refer servicing to qualified._ __..' _-_,.r._ a_p_uct.
personnel only.
Model No. uvl_-_r_ _: _" "
CAUTION .... ""_-'--_ "nl __._:,_._.. _ . ., . : .
The use of optical instruments with this
product will increase eye hazard. As the
laser beam used in this CD/DVD player is
ha_fu] to eyes, do not attempt to
disassemble the cabinet.
Refer servicing to qualified personnel only.
EOL._A
..... [d_._,_-_ _, .I. r rgdd_ugit. Record the
CAUTION
You are cautioned that any change or
modifications not express]y approved in
this manual could void your authority to
operate this equipment.
...._j •
Thazd< you for purchasing this Sony CD/
DVD Player. Befo_ operating the unit,
please read this manual thoroughly and
retain it for future reference.
i AUTION"
Laserradiationwhenopen.
DO NOT STAREINTO BEAM.i J
ij
This label is located on the left side
enclosure (Laser protective housing).
/_ This syn_boI is intended to
alert the user to the presence
of uninsulated "dangerous
voltage" within the
product's enclosure that may
be of sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to
alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
NOTE:
This eqult_ment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful inter ferelace in a l_esidentlal
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructiops, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the receiving
anteltqa.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on
a circuit different from that to which the
i_ceiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
accompanying the appliance.
CAUTION
TO PREVENT ELECTRIC SHOCK
MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
2
To Next Page
Loading...
