Getting
Started
This section describes how to hook up
the CD/DVD player to a TV (with
audio/video input jacks) and/or an
AV receiver (amplifier). You cannot
connect this player to a TV which
does not have a video input
connector. Be sure to turn off the
power of each component before
making the connections.
Unpacking
Check that you have the following items:
• Audio/video connecting cord (1)
• S video cord (1)
• Remote commander (remote) RMT-D119A (1)
• Size AA (R6) batteries (2)
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert two Size AA (R6) batteries by matching the + and -
ends on the batteries to the markings inside the
compartment. When using the remote, point it at the
remote sensor Imon the playen
_m
;I
¢
el
YoucancontrolTVsorAVreceivers(amplifiers)usingthe
suppliedremote
See page 58.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
* Do not expose the remote sensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
Transporting the player
Before transporting the player, follow the procedure
below to return the internal mechanisms to their original
positions.
1 Remove all the discs from the disc tray.
Press_ to close the disc tray.
Make sure that "NO DISC" appears on the front panel
display.
3 Wait for 10 seconds, then press I/_) on the remote,
followed by _ on the player.
This will safely turn off the player.
7
To Next Page
Loading...
