Sony ICP-X1224 - Preventing Operation of a Cross-Point Button Row (Protect Function)

93
Preventing Operation of a Cross-
Point Button Row (Protect Function)
You can temporarily prevent button operations for each
cross-point button row on the cross-point control block.
To enable/disable the protect function, use the following
bu
ttons.
• ICP-X7000: [ROW-1 PROT] button to [ROW-4
P
ROT] button assigned to the cross-point pad
• ICP-X1000 series: [PROT] button in the 1st row to 4th
ro
w assigned to the function button section
To protect a cross-point button row
Press the [ROW-1 PROT] button to [ROW-4 PROT]
bu
tton/[PROT] button, turning it on, for the target cross-
point button row (1st row to 4th row) to set.
To release the protection setting for a cross-
po
int button row
Press the [ROW-1 PROT] button to [ROW-4 PROT]
b
utton/[PROT] button, turning it off, for the target cross-
point button row (1st row to 4th row) to release.