Sony NXCAM HXR-NX80 User Manual

21
Getting Started
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (V series) with the
supplied AC Adaptor.
b Note
• You can use an NP-FV100A large capacity
battery pack (sold separately) with your
camcorder. You cannot use an NP-FV50A.
1 Close the LCD screen and store
the viewfinder before attaching
the battery.
2 Connect the AC Adaptor and
power cord from the camcorder
to an outlet.
The CHG lamp lights up and charging
starts.
When charging ends
The CHG lamp turns off when the battery is
fully charged.
Disconnect the AC Adaptor from the DC
IN jack.
z Tip
• You can check the remaining battery life with
the status check function (p. 68).
To remove the battery pack
Turn the power off, then slide the BATT
release lever to release the battery.
Battery
Power cord
DC IN jack
DC plug
To power outlet
AC Adaptor
Continued ,

Sony NXCAM HXR-NX80 Specifications

General

Lens	ZEISS Vario-Sonnar T*
Optical Zoom	12x
ND Filter	Clear, 1/4, 1/16, 1/64
Image Stabilization	Optical SteadyShot with Active Mode
Maximum Resolution	3840 x 2160 (4K)
Microphone	Built-in stereo microphone
Memory Card Slots	Dual SD card slots
Effective Pixels	14.2MP
Digital Zoom	48x
Focal Length	9.3 - 111.6 mm
Aperture	f/2.8 - f/4.5
Minimum Focusing Distance	1 cm (Wide)
Recording Format	XAVC S, AVCHD
Frame Rate	Up to 120fps (HD)
Audio Recording	Linear PCM 2ch, Dolby Digital 2ch
LCD Screen	3.5-inch (1.56 million dots) touchscreen LCD
Viewfinder	0.39-inch type OLED, approx. 2.36 million dots
Battery	NP-FV70A
Dimensions	89.5 x
Connectivity	HDMI, USB, Wi-Fi, NFC