EasyManuals Logo

Sony NXCAM HXR-NX80 User Manual

Sony NXCAM HXR-NX80
171 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
62
When [60i] is selected
When [50i] is selected
b Notes
The supported memory cards that can be used
vary depending on the file format (p. 27).
In Super Slow Motion recording, the camcorder
may continue recording after you press the
START/STOP button to stop recording (up to 3
minutes). Do not operate your camcorder while
the [REC] indicator is flashing on the screen,
and wait till it turns to [STBY].
After you stop recording, your camcorder
continues recording till it completes writing 0.5
seconds unit of data.
The shutter value may not be displayed
correctly when recording in Super Slow Motion
if [SHUTTER DISPLAY] is set to [DEGREE]
(p. 120).
Available only when the AUTO/MANUAL
switch is set to MANUAL. Note that iris, ISO
sensitivity/gain, and shutter speed are fixed to
manual.
When the [FRAME RATE] is set to [960]
([1000]), the image displayed and recorded
shifts approximately 1.35 times toward the
telephoto side.
When the [FRAME RATE] is set to [480] or
[960] ([500] or [1000]), the picture will be
slightly degraded relative to normal shooting.
Changing the ISO sensitivity/gain, shutter
speed, or white balance will cause degradation
of the image on the LCD screen, but the camera
settings in force when shooting ends are applied
to the recorded image. For details about
displaying camera data, see page 67.
To change the frame rate setting, first stop
recording.
The timecode is recorded in [REC RUN] mode
(p. 123).
Super Slow Motion mode is automatically
canceled when the camcorder is turned off, but
the [FRAME RATE] setting is retained.
Flicker correction has no effect.
You cannot record sound.
The auto focus function is not supported.
Shutter speeds slower than the frame rate cannot
be selected.
Super Slow Motion recording is not supported
when the file format is XAVC S 4K.
For details about Super Slow Motion
limitations, see “Slow & Quick Motion and
Super Slow Motion recording limitations”
(p. 152).
You can review the most recently recorded
scene on the LCD screen.
You can assign this function to an ASSIGN
button.
For details about function assignment
operation to an ASSIGN button, see
“Assigning functions to the ASSIGN
buttons” (p. 64).
FRAME
RATE
REC TIMING
START
TRIGGER
END
TRIGGER
END
TRIGGER
HALF
960 Approx.
3sec.
Approx.
3sec.
Approx.
1 sec.
480 Approx.
4sec.
Approx.
4sec.
Approx.
2 sec.
240 Approx.
5sec.
Approx.
5sec.
Approx.
2 sec.
FRAME
RATE
REC TIMING
START
TRIGGER
END
TRIGGER
END
TRIGGER
HALF
1000 Approx.
3sec.
Approx.
3sec.
Approx.
1 sec.
500 Approx.
4sec.
Approx.
4sec.
Approx.
2 sec.
250 Approx.
5sec.
Approx.
5sec.
Approx.
2 sec.
Reviewing the most recently
recorded scene (Last Scene
Review)
Useful functions (Continued)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sony NXCAM HXR-NX80 and is the answer not in the manual?

Sony NXCAM HXR-NX80 Specifications

General IconGeneral
LensZEISS Vario-Sonnar T*
Optical Zoom12x
ND FilterClear, 1/4, 1/16, 1/64
Image StabilizationOptical SteadyShot with Active Mode
Maximum Resolution3840 x 2160 (4K)
MicrophoneBuilt-in stereo microphone
Memory Card SlotsDual SD card slots
Effective Pixels14.2MP
Digital Zoom48x
Focal Length9.3 - 111.6 mm
Aperturef/2.8 - f/4.5
Minimum Focusing Distance1 cm (Wide)
Recording FormatXAVC S, AVCHD
Frame RateUp to 120fps (HD)
Audio RecordingLinear PCM 2ch, Dolby Digital 2ch
LCD Screen3.5-inch (1.56 million dots) touchscreen LCD
Viewfinder0.39-inch type OLED, approx. 2.36 million dots
BatteryNP-FV70A
Dimensions89.5 x
ConnectivityHDMI, USB, Wi-Fi, NFC

Related product manuals