Sony NXCAM HXR-NX80 User Manual

77
Using Network Functions
3 Confirm connection to the SSID
displayed on the camcorder.
4 Return to the Home screen, then
start “Content Browser Mobile.”
Configuring a wireless
LAN
You can connect the camcorder to a
network using a wireless LAN.
b Note
• The frequency band used by the wireless LAN
module is part of the frequency spectrum shared
by various other devices.
The communication speed and communication
distance may be reduced, and communication
may even be interrupted, depending on the
usage environment and interference with other
devices. If this occurs, try changing the channel
of the access point.
You can connect the camcorder and an
access point using a wireless LAN.
1 Press the MENU button.
2 Select (NETWORK SET) t
[Wi-Fi SET] t [ACCESS POINT
SET].
After a short delay, a list of access
points that can be connected is
displayed.
3 Select an access point to register.
If an access point you want to register is
not displayed, select [Manual setting]
and configure settings manually (p. 80).
4 Enter the password, and select
[Next].
Password entry is not required for
access points that do not display .
Selecting and registering an
access point
Continued ,

Sony NXCAM HXR-NX80 Specifications

General

Lens	ZEISS Vario-Sonnar T*
Optical Zoom	12x
ND Filter	Clear, 1/4, 1/16, 1/64
Image Stabilization	Optical SteadyShot with Active Mode
Maximum Resolution	3840 x 2160 (4K)
Microphone	Built-in stereo microphone
Memory Card Slots	Dual SD card slots
Effective Pixels	14.2MP
Digital Zoom	48x
Focal Length	9.3 - 111.6 mm
Aperture	f/2.8 - f/4.5
Minimum Focusing Distance	1 cm (Wide)
Recording Format	XAVC S, AVCHD
Frame Rate	Up to 120fps (HD)
Audio Recording	Linear PCM 2ch, Dolby Digital 2ch
LCD Screen	3.5-inch (1.56 million dots) touchscreen LCD
Viewfinder	0.39-inch type OLED, approx. 2.36 million dots
Battery	NP-FV70A
Dimensions	89.5 x
Connectivity	HDMI, USB, Wi-Fi, NFC