Performing
auto
calibration
For details on the auto calibration, see "9:
Calibrating the appropriate
speaker
settings
autolnatically
(Auto
Calibration)" (page 43).
Refer to
"Before
you perform the auto
calibration" (page
43)
before
performing the
auto calibration.
Tips
• Operations
other
than turning the receiver on
or
off
are deactivated during auto calibration.
• In the following situations, the measurements may
not
be
performed correctly
or
auto calibration
cannot
be
performed.
- when special speakers, such as dipole speakers
are used.
- when the multi zone function is used in zone
2.
To
confirm/save
auto
calibration
when GUI
function
is
turned
off
1 Confirm the measurement result.
When
the
measurement
ends, a
beep
sounds
and
the
measurement
result appears
on the display.
To
operate on the receiver
1 Press SHIFT, then press MENU to set
the GUI display mode to off.
The
menu appears on the
TV
screen
when
"GUI
MODE"
appears
on
the display.
2 Press AMP.
Receiver operation is enabled.
Measurement Display
result
Explanation
COMPLETE
Proceed to step
2.
3 Press MENU.
"Auto
Calibration"
is displayed.
4 Press
8.
5 Press
+1+
repeatedly to select "AUTO
CAL START?
;'
then press 8 to start
the measurement.
Measurement
starts in five seconds. A
count
down is displayed.
When
the
measurement
process
completes
properly
When
the
measurement
process fails
ERROR
CODE
3.
See
"Message
list after auto
calibration
measurement"
(page 48).
RETRY Re-performs the auto
calibration.
DIST.INFO Displays the measurement
result for speaker distance.
SAVE
EXIT
Saves the
measurement
results and exits the setting
process.
2 Press
+1+
repeatedly to select the item,
then press
(8.
The
measurement
results are saved.
Explanation
Item
PHASE
INFO
Displays the phase
of
each
speaker (in phase/out
of
phase). See
"When
you select
"PHASE
INFO"".
WRN
CHECK
Displays a warning
concerning the measurement
results. See
"When
you select
"WRN
CHECK""
(page 48).
6 Measurement starts.
The
measurement
process will take
approximately
30
seconds. Wait until the
measurement
process completes.
To cancel auto calibration,
change
the volume,
activate the
MUTING
function, switch
functions,
change
the setting
of
the
SPEAKERS
switch
of
the receiver,
or
connect
headphones.
Note
You cannot measure the
speaker
height
of
the
surround speakers and the surround
back
speakers.
Set this value from
"SP
POS!." settings in the
Speaker
settings menu.
Note
While
the time is counting down, stand away
from the measurement area to avoid
measurement
error.
112
GB
To Next Page
Loading...
