Starting macro play
1 Press AMP.
The AMP button lights up, and then turns
off.
2 Press MACRO 1 or MACRO 2 to start
the macro.
The macro starts and execute the
commands in the order you assigned them.
While the commands are being sent, the
RM SET UP button flashes and the
AMP
button lights up. When the commands have
been sent, the RM
SET
UP and
AMP
buttons turn off.
To
erase a programmed macro
1 Press MACRO 1 or MACRO 2 for more
than 1 second while pressing
RM
SET
UP to clear the stored macro.
The RM SET UP button flashes,
repeatedl
y.
2 Press
RM
SET UP.
Settings stored as macro are cleared.
124
GB
Setting
remote
control
codes
that
are
not
stored
in
the
remote
Even
if
a remote control code is not one
of
the
presets stored in the remote, it is possible for
the remote to learn the code using the learning
function.
Note
When setting up the receiver to learn the remote
command
modes, replace the batteries with new
ones.
1,6---
1
2
Example for assigning
numeric
button
1 to
VIDEO 1
of
the remote:
1 Press TV while pressing RM
SET
UP.
The
RM
SET
UP
button lights up.
Tip
When you press RM
SET
UP, use a thin wire,
such as a paper clip.
2 Press the input button (VIDEO 1
in
the example) for which you
want to use the Learning input
function.
The input button flashes. (The
RM
SET
UP
button remains lit.)
To Next Page
Loading...
