"1111111111111111111111
Settings
for
the
audio
(Audio
settings
menu)
You
can use the Audio settings menu to make
settings for the audio to suit your preference.
Select
"Audio"
in the Settings menu. For
details on adjusting the parameters, see "7:
Operating the receiver using the
GUI
(Graphical User Interface)" (page 38).
•
A1V
Sync
(Synchronizes audio and video
output)
Lets you delay the output
of
audio to minimize
the time gap between audio output and visual
display.
You
can adjust the delay from 0 ms to
300
ms in
10
ms steps.
Notes
• This function is useful when you use a large
LCD
or
plasma
monitor
or
a projector.
• You can adjust the delay to up to 300 ms
-
The
sampling frequency is less than 48 kHz.
- 2 channel analog signals.
•
You
can adjust the delay to up to 150 ms
-
The
sampling frequency is 88.2 kHz
or
96 kHz.
Although the parameter appears up to
300
ms at
this time, you cannot adjust the delay by more than
150 ms.
• This function does not work in the following cases.
-
The
multi-channel input is selected.
- Input signals
of
which the sampling frequency is
more than 96
kHz
are being received.
-
The
multi-channel Linear
PCM
signals are
received via an
HDMI
IN
jack.
-
"2ch
Analog Direct" is being used.
-
"Neural-
THX"
is selected as the sound field
type.
56
GB
• Dual Mono
(Digital broadcast language
selection)
Lets you select the language you want to listen
to during a digital broadcast. This feature only
functions for Dolby Digital sources.
• MAIN/SUB
Sound
of
the main language will be output
through the front left speaker, and sound
of
the sub language will be output through the
front right speaker simultaneously.
•
MAIN
Sound
of
the main language will be output.
• SUB
Sound
of
the sub language will be output.
•
MAIN+SUB
Mixed sound
of
both the main and sub
languages will be output.
• Decode Priority
(Digital audio input decoding
priority)
Lets you specify the input mode for the digital
signal input to the DIGITAL IN
jacks
or
HDMI
IN jacks.
•
PCM
When
signals from the DIGITAL IN
jack
are
selected,
PCM
signals are given priority (to
prevent interruption when playback starts).
However, when other signals are input, there
may be no sound, depending on the format.
In this case, set this item to "AUTO."
When
signals from the
HDMI
IN
jack
are
selected, only
PCM
signals are output from
the connected player.
When
signals in any
other format are received, set this item to
"AUTO."
• AUTO
Automatically switches the input mode
between DTS, Dolby Digital,
or
PCM.
Note
When
set to
"AUTO"
and the sound from the digital
audio
jacks
(for a
CD,
etc.) is interrupted when
playback starts, set to
"PCM."
To Next Page
Loading...
