Sony STR-DA3300ES - Page 130

• Do not place the receiver near heat sources,
or
in a place subject to direct sunlight,
excessive dust, or tnechanical shock.
• Do not place anything on top
of the cabinet
that might block the ventilation holes and
cause tnalfunctions.
• Do not place the receiver near equipment
such as a television, VCR,
or tape deck. (If
the receiver
is being used in combination
with a television, VCR, or tape deck, and is
placed too close to that equipment, noise
may result, and picture quality may suffer.
This
is especially likely when using an
indoor antenna (aerial). Therefore, we
recommend using an outdoor antenna
(aerial).)
On operation
Before connecting other components, be sure
to turn
off and unplug the receiver.
On cleaning
Clean the cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution.
Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol
or benzine.
If you have any questions
or problems
concerning your receiver, please consult your
nearest Sony dealer.
130
GB
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.
Audio
There is no sound, no matter which
component is selected, or only a very
low-level sound is heard.
• Check that the speakers and components
are connected securely.
•
Check that all speaker cords are connected
correctly.
•
Check that both the receiver and all
components are turned on.
• Check that
MASTER VOLUME control is
not set at
-00 dB. Try to set it at about -40
dB.
• Check that SPEAKERS (OFF/A/B/A+B)
is not set to
OFF (page 43).
• Press
MUTING on the remote to cancel
the muting function.
• Check that you have selected the correct
component with INPUT SELECTOR.
• Check that headphones are not connected.
•
When only a very low-level sound is
heard, check to see
if NIGHT MODE is
activated (page 67).
• The protective device on the receiver has
been activated. Turn
off the receiver,
eliminate the short-circuit problem, and
tum on the power again.
There is no sound from a specific
component.
• Check that the component is connected
correctly to the audio input
jacks for that
component.
•
Check that the cord(s) used for the
connection
is (are) fully inserted into the
jacks on both the receiver and the
component.