b)
If you connect only one surround back
speaker, connect it to the
SUR
BACK
SPEAKERS L terminals.
c) When you connect a sub woofer with an auto
standby function,
tum
offthe function when
watching movies.
If
the auto standby
function is set to on, it turns to standby mode
automatically based
on
the level
of
the input
signal to a sub woofer, then sound may not
be output.
Notes
• When you connect all the speakers with a nominal
impedance
of
8 ohms
or
higher, set "Impedance" in
the Speaker settings menu to
"8
n." In other
connections, set it to "4
n." For details, see "8:
Setting the speakers" (page 41).
• Before connecting the AC power cord (mains
lead), make sure that metallic wires
of
the speaker
cords are not touching each other between the
SPEAKERS terminals.
Tip
To
connect certain speakers to another power
amplifier, use the PRE
OUT
jacks.
The
same signal
is output from both the
SPEAKERS
terminals and
the PRE
OUT
jacks. For example,
if
you want to
connect
just
the front speakers to another amplifier,
connect that amplifier to the PRE
OUT
FRONT L
and R jacks.
You can assign the
SUR
BACK SPEAKERS
terminals
II and mto the speakers
of
the
zone
2.
Set
"Sur
Back Assign" to
"ZONE
2" in
the Speaker settings menu.
See "Listening to the sound in another zone
(ZONE 2 operations)" (page 101) for details
on connection and operation in zone 2.
18
GB
To Next Page
Loading...
