III
Turn on the receiver while pressing
2CH/A.DIRECT.
When the command mode is set to "AV2,"
"COMMAND
MODE [AV2]" appears on the
display.
When the command mode is set to
"A
V1
,"
"COMMAND
MODE [AVl]" appears on the
display.
To
switch the command mode
of the RM-AAL011 remote
2CH/A.DIRECT
To
switch the command mode
of the receiver
You can switch the command mode
(AV
SYSTEM 1 or
AV
SYSTEM 2)
of
the receiver
and the remote.
If
both the receiver and the
other Sony component respond to the same
remote command, switch the command mode
of
either the component
or
the receiver to
anothercommandmode so that the component
does notrespond to the same remote command
as the receiver.
RM-AAU018
/
RM-AAL011
Notes
• Do not leave the remote in an extremely hot or
humid place.
•
Do
not use a new battery with old ones.
• Do not mix manganese batteries and other kinds
of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
•
If
you do not intend to use the remote for an
extended period
of
time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared.
If
this happens,
program the remote codes again (page 119).
Insert two R6 (size-AA) batteries in the RM-
AALOll
remote commander.
Insert two R6 (size-AA) batteries in the RM-
AAUO
18 remote control.
Observe the correct polarity when installing
batteries.
continued------
Tip
When the remote no longer operates the receiver,
replace all the batteries with new ones.
The receiver and the remote use the same
command mode.
If
the command modes
of
the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
If
the command modes
of
both the receiverand
the remote are those
of
the initial setting
(AV
SYSTEM 2), it is not necessary to reset them.
1
1
2
3
37
GB
To Next Page
Loading...
