Sony STR-DA5200ES - Page 106

106
GB
2 Press V/v repeatedly to select the item,
then press .
3 Press .
The measurement results are saved.
4 Press V/v repeatedly to select “AUTO
EQ,” then press .
5 Press V/v repeatedly to select the
parameter, then press .
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Auto Calibration
settings menu (page 71). Save the measurement
results first, then try to change the settings if you
want.
When you select “PHASE INFO”
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a speaker,
then press to return to step 1 in
“Confirming/saving the measurement
results.”
Tip
Depending on the position of the sub woofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
For details on each sound field type, see
“Enjoying a pre-programmed sound field”
(page 58).
Press 2CH, A.F.D., MOVIE, or
MUSIC repeatedly.
The selected sound field type appears on the
display.
Item Explanation
RETRY Re-performs the auto
calibration.
SAVE EXIT Saves the measurement
results and exits the setting
process.
WRN CHECK Displays a warning
concerning the measurement
results. See “When you select
“WRN CHECK”” (page 47).
PHASE INFO Displays the phase of each
speaker (in phase/out of
phase). See “When you select
“PHASE INFO””.
DIST.INFO Displays the measurement
result for speaker distance.
LEVEL INFO Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
AUTO EQ type Explanation
ENGINEER Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
FULL FLAT Makes the measurement of
frequency from each speaker
flat.
FRONT REF Adjusts the characteristics of
all the speakers to match the
characteristics of the front
speaker.
OFF Set the auto calibration type
to off.
Display Explanation
IN-PHASE The speaker is in phase.
OUT-OF-
PHASE
The speaker is out of phase. The
“+” and “–” terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
“OUT-OF-PHASE” appears on
the display even though the
speakers are connected properly.
This is because of the speakers’
specifications. In this case, you
can continue to use the receiver.
---------- No speakers are connected.
Selecting a sound field type