34 (GB) Before adjustment
Before adjustment
Adjustment procedures
Perform each adjustment with the supplied remote control before
connecting to the external equipment. After the adjustment, save the data.
Next, perform fine adjustment for each input signal connected to the
projector.
Follow the procedure below.
1 Prepare the remote control. (page 35 (GB))
.
2 Set the remote control to the service adjustment mode. (page 35 (GB))
.
3 Adjust roughly without input signal. (pages 60 (GB) to 87 (GB))
.
4 Save the adjustment data as the standard data. (page 88 (GB))
.
5 Adjust fine for each input signal. (pages 89 (GB) to 95 (GB))
.
6 Activate the memory protection of the remote control. (page 101 (GB))
.
7 Adjust the picture. (page 102 (GB))
Adjustment Procedures
To Next Page
Loading...
