Before adjustment 33 (GB)
Before adjustment
Before adjustment
Adjustment Procedures
Warm-up before adjustment
Before adjusting the registration, make sure to turn on the projector and
allow it to warm up for 20 minutes.
The projector is designed with a warm-up period of about 20 minutes after
turning on the power. During this period, it displays a white screen with
the message shown below. 35 seconds after the warm–up starts, the
message will disappear temporarily and will appear subsequently for 5
seconds every 30 seconds.
Press the MENU key to cancel the warm–up, if you wish to see the picture
immediately.
You may also set the projector for a shorter, longer or no warm–up period.
For details, see “Changing the Initialization Period” on page 103 (GB).
INPUT-A
For optimum
performance
white screen will
remain for 20min.
For immediate use,
push [MENU] key.
To Next Page
Loading...
