Before adjustment 51 (GB)
Before adjustment
V (Vertical)-SYNC
Indicates the polarity of the vertical or composite sync
signal.
When the picture is being projected using this type of
sync signal, the POS (NEG) is displayed in green.
When the picture is being projected without using this
type of sync signal, the POS (NEG) is displayed in
white.
POS: The polarity of the sync signal is positive.
NEG: The polarity of the sync signal is negative.
– – –: No sync signal is input.
SonG (Sync on Green)
Indicates the polarity of the sync on Green. When the
picture is being projected using this type of sync
signal, the NEG is displayed in green. When the
picture is being projected without using this type of
sync signal, the NEG is displayed in white.
NEG: The polarity of the sync signal is negative.
– – –: No sync signal is input.
INPUT SIGNAL
Displays the type of current input signal.
NTSC 3.58: NTSC
3.58
input signal
PAL: PAL input signal
SECAM: SECAM input signal
NTSC 4.43: NTSC
4.43
input signal
PAL-M: PAL-M input signal
B/W: Black and white input signal
Y/C: S video input signal
RGB: RGB input signal
COMPONENT: Component (Y/R-Y/B-Y, Y/C
B/CR)
input signal
HDTV YPBPR: HDTV YP
B
P
R
input signal
HDTV GBR: HDTV GBR input signal
IDTV: When ON is selected.
INPUT MEMORY No.
The upper number is the memory number of the data
automatically loaded when the current signal is input.
The lower number is the new memory number in
which the adjustment data of the current input signal is
stored. The existent memory number is displayed in
green, and a new memory number in yellow.
For details, see “Memory structure” on page 96 (GB).
By default seven basic data are stored in the following
memory numbers.
Memory
number
00
01
02
03
04
05
06
FREQUENCY SENSITIVITY
Selects the sensitivity to the frequency deviation of the
input signal, with which the INPUT MEMORY data is
switched automatically. This item can be selected only
for RGB input signals.
Press the b key or the ENTER key on the INPUT
INFO menu, and the INPUT MEM. OPTION menu
appears. Press the b key or the ENTER key again to
show the frequency sensitivity options.
HIGH: This position is selected at the factory.
LOW: Set to this position if the input signal is
unstable or flickers. This phenomenon may appear
during variable speed playback by the VCR, etc.
Types of the
input signal
Video (NTSC
3.58)
RGB
RGB
RGB
RGB
IDTV (NTSC
3.58)
HDTV (Y/PB/PR)
fH
15.7 kHz
24.8 kHz
31.5 kHz
48.3 kHz
64.0 kHz
31.5 kHz
33.8 kHz
Preset signal
frequencies
fV
60 Hz
56 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
To Next Page
Loading...
