48 User manual 208898
6. Troubleshooting and Maintenance CRANEX Novus e
Correct operation of the unit
If any of the unit’s controls, displays or functions fail
to operate or do not operate in the way described in
this manual, switch the unit off, wait 30 seconds and
then switch the unit on again. If the unit still does
not operate correctly contact your service technician
for help.
If you hear the exposure warning tone but the
exposure warning light does not come on when an
exposure is taken, stop using the unit and contact
your service technician for help.
If you do not hear the exposure warning tone when
an exposure is taken, stop using the unit and
contact your service technician for help.
Every week check that the power supply cable is
in good order (not damaged in any way) and that
the unit operates correctly in accordance with the
instructions in this manual.
Make sure that the unit cannot be driven up/down
when the emergency stop button has been pressed
down.
Approved: Ukkonen Juha-Pekka 2015-03-13 13:08
Reviewed: Savinen Antti Juhani 2015-03-12 11:32
Approved
See PDM system to determine the status of this document. Printed out: 2016-01-27 12:19:26
D508980, 4
Copyright © 2015 by PaloDEx Group Oy. All rights reserved.
To Next Page
Loading...
