Operation
33
BIOshield
®
Rotor 7500 6435
The bucket set is a permanent part of the rotor and
must not be interchanged with any different rotor.
Do not run the rotor without the rotor cover installed.
The rotor cover is installed and removed by pushing
down and turning the cover locking knob.
Store the BIOshield
®
Rotor with the cover
removed after cleaning. This will enable the
rotor to dry thoroughly.
The rotor has to be retired upon
reaching the end of its life, which
depends on the number of runs that
may be performed, and varies de-
pending on run speed.
Exceeding the maximum number of
cycles can result in rotor failure with
subsequent damage to the centri-
fuge!
max. speed max. number of runs
allowed
5850 rpm
5350 r
To Next Page
Loading...
