System Components
39
3.3.7 Charging the ViSi Mobile Monitor and Cuff Module
The ViSi Mobile Charger provided by Sotera Wireless, Inc. is the required Charger for both the Monitor
and the Cuff Module as well as for the optional ViSi Power Pack. The Charger is capable of charging up to
eight of any combination of Monitors, Cuff Modules and Power Packs. To charge either the Monitor or the
Cuff Module place the flat end into one of the slots with the front facing outwards.
Note: The ViSi Mobile Charger is to be used for ViSi Mobile components only.
ViSi Mobile Monitors and Cuff Modules contain sealed batteries that are not replaceable by the user.
If a Monitor or Cuff Module has a battery issue, contact the Sotera Wireless, Inc. Customer Service
Department.The LED on the Charger is used to indicate the charging status of devices that are currently
inserted:
LED Color Charging Status
Steady Green Everything is functional:
• No devices in the Charger.
• All devices are charging normally or are fully charged.
Flashing Green /
Yellow
At least one device in the Charger has not properly registered with the Charger, but
charging continues on all devices. Devices with fully drained batteries cannot register
with the Charger until after a charge cycle starts and will cause this condition until they
reach a minimum charge level. Removing and reinserting an unregistered device can
give it another chance to register in the Charger. If this condition is repeatedly observed
on devices that are not fully drained, contact Sotera Wireless, Inc. or an authorized
Sotera Wireless, Inc. representative in your area.
Steady Yellow At least one device in the Charger is not being charged due to a fault with the device.
All other devices are charging.
Contact Sotera Wireless, Inc. or an authorized Sotera Wireless, Inc. representative in
your area.
Steady Red Charger fault. No devices are charging, the Charger has shutdown.
Contact Sotera Wireless, Inc. or an authorized Sotera Wireless, Inc. representative in
your area.
To Next Page