Space ER 200 - Fitting the Shaft on the Flange; Fitting the Protection Guard (Mod. ER165 Only)

INSTRUCTION MANUAL
SPACE s.r.l.
ER 200 - ER 220
ER150 - ER160 - ER165
Code M0076 - rev.1.6
(04/2005)
Page 10/ 40 SPACE s.r.l. – 10090 Trana (TO) Via Sangano, 48
Tel. (+39) 011/ 933.88.65 – Fax (+39) 011/ 933.88.64
e-mail: info@spacetest.com
Figure 1
4.2.1 Fitting the shaft on the flange
Figure 2
4.2.2 Fitting the protection guard (mod. ER165 only)
Figure 3
Fasten the shaft on the
flange using a setscrew
wrench
Check this is touching at the 4
support points provided.
Add shims as required;
Anchor if wheels are used
weighing > a 30kg
c
Tighten the 4 screws
sustaining the guard support
in the special inserts
positioned in the rear of the
unit using a socket wrench
d
fit the spring between
the base of the support
and the anchor pin
MEASUREMENTS IN MILLIMETRES
ER200
ER220
ER150
ER160
ER165