INSTRUCTION MANUAL
SPACE s.r.l.
ER 200 - ER 220
ER150 - ER160 - ER165
Code M0076 - rev.1.6
(04/2005)
Page 4/ 40 SPACE s.r.l. – 10090 Trana (TO) Via Sangano, 48
Tel. (+39) 011/ 933.88.65 – Fax (+39) 011/ 933.88.64
e-mail: info@spacetest.com
2 OPERATOR TRAINING
The machine must only be used by specifically trained and authorised personnel. To
ensure proper machine use and that measurements can be efficiently taken, operators
must be correctly trained and acquire the skills consistent with the instructions provided
by the manufacturer. In case of any doubts relating to machine use and maintenance,
refer to the instruction manual and then, if such doubts persist, contact an authorised
after-sales centre or SPACE s.r.l. technical assistance directly.
2.1 General preventive measures
•
During operation and maintenance of this machine, always abide by the
safety and accident-prevention regulations in force.
•
The machine must only be used by adequately trained and authorised
persons.
•
UNDER NO CIRCUMSTANCES must the machine be used to spin anything
but vehicle wheels. Bad locking can cause rotating parts to come loose, with
potential damage to the machine and anything in the vicinity and injury to
the operator.
•
This machine must only be used for the purpose for which it was expressly
intended.
SPACE s.r.l. declines all liability for injury or damage to persons animals and
things caused by improper machine use.
•
Accessories and spare parts must be fitted by persons authorised by
SPACE s.r.l. and only original spare parts and accessories must be used.
•
Operators should wear suitable protective clothing like gloves, safety
•
The machine must only be operated in places where there is no danger of
explosions or fire.
•
Removal or changes made to safety devices, or warning signals on the
machine can cause serious hazards and represents a violation of European
safety regulations.
•
Before doing any maintenance jobs on the system, always disconnect the
power supply.
In case of doubt, do not interpret, but contact SPACE s.r.l. technical
assistance in order to obtain instructions suitable for performing operations
in total safety.
•
Wheel balancer operators must not wear loose clothing, hanging ties, chains
or other accessories that could become trapped. Long hair should be properly
collected up and tied or protected.
•
Do not allow unauthorised personnel to come near the wheel balancer during
the cycle.
2.2 Indication of outstanding risks
The machine was designed and manufactured in compliance with applicable regulations. The
risks connected to the use of the machine have been eliminated as far as possible. Other
outstanding risks are described in this manual; the machine also features self-adhesive
pictograms (chap. 3 on page 5) indicating hazard areas. In the event pictograms become
illegible, please order them from a dealer or directly from SPACE s.r.l. and replace them.
Please refer to Spare Parts manuals.
To Next Page
Loading...