INSTRUCTION MANUAL
SPACE s.r.l.
ER 200 - ER 220
ER150 - ER160 - ER165
Code M0076 - rev.1.6
(04/2005)
Page 2/ 40 SPACE s.r.l. – 10090 Trana (TO) Via Sangano, 48
Tel. (+39) 011/ 933.88.65 – Fax (+39) 011/ 933.88.64
e-mail: info@spacetest.com
0 INSTRUCTIONS
Any damage caused by failure to follow the instructions in this manual or improper
machine use shall relieve SPACE s.r.l. of all liability.
0.1 Preliminary safety information
Before starting the machine:
•
Read the instructions and the entire manual before using or working on the wheel
balancer. This manual represents an integral part of the product and is intended to
inform the user on how to use the wheel balancer model ER200, ER220, ER150,
ER160 and ER165. Look after the manual for the entire life of the machine. Keep it in
an easy to access place and refer to it every time the need arises. All machine
operators must be able to read the manual.
•
Make sure the power supply is in conformity with the specifications shown on the
plate.
•
Make sure the machine is properly positioned on the floor.
•
Suitably position the machine power cables.
On starting the machine:
•
Remove any foreign bodies from the tyre before spinning the wheel.
•
Make sure the counterweights are fitted properly before spinning the wheel again.
In emergency conditions and before performing any maintenance:
•
Isolate the machine from any power sources by means of the machine master switch.
Work environment and machine cleaning:
•
The work environment must be kept clean and dry and must not be exposed to
atmospheric agents. It must also be well lit.
•
Do not clean the machine using strong jets of water and compressed air.
•
To clean plastic panels or tops, use alcohol (always avoid liquids containing solvents).
SPACE s.r.l. shall be entitled to make any changes to the models described in this manual a
any time for reasons of a technical and commercial nature
To Next Page
Loading...