Spectra Engineering MX800 - Options (continued); 3.17.1 Installation; 3.17.2 2 Wire or 4 Wire Selection, Balanced VF; 3.17.3 VF Delay

MX800 Transceiver Technical Manual
© SPECTRA ENGINEERING 2006 Revision 4.2.3
x
List of Figures
Figure 1-1 Standard Front Panel ...............................................................................4
Figure 1-2 Local Control Front Panel .......................................................................4
Figure 1-3 MX800 Rear Panel ...................................................................................6
Figure 1-4 MX800 Side Panel ....................................................................................7
Figure 3-1 MX800 T01 Option, Programable bandwidth fitted to RX module. ........19
Figure 3-2MX800 DCS Option T03...........................................................................21
Figure 3-3 CN9 RJ45 Pin-out Detail (View from Rear of MX800)..........................23
Figure 3-4 MX800 Option T05 Balanced & Isolated VF I/O with E&M leads.........25
Figure 3-5 CN9 RJ45 Pin-out Detail (View from Rear of MX800)..........................26
Figure 3-6 T06 Simplex Changeover Relay...............................................................27
Figure 3-7MX800 T08,T09,T10 Option board complete...........................................30
Figure 3-8 Front Panel with Speaker, Mic and Mute...............................................40
Figure 3-9 RJ45 socket viewed from front of MX800...............................................41
Figure 3-10 MX800 T19/T26Option Board...............................................................48
Figure 3-11 CN3 Pin-out Detail (View from Rear of MX800) ..................................58
Figure 3-12 CN9 RJ45 Pin-out Detail (View from Rear of MX800)........................59
Figure 3-13 MX800 T29 otpion board.......................................................................61
Figure 3-14 CN9 RJ45 Pin-out Detail (View from Rear of MX800) .........................62
Figure 3-15 T31 Option Board..................................................................................63
Figure 3-16 U72 Dongle............................................................................................64
Figure 3-17 U73 Dongle............................................................................................64
Figure 4-1 MX800 Top View ....................................................................................66
Figure 5-1 Under (increase level) ............................................................................78
Figure 5-2 Over (decrease level)..............................................................................78
Figure 5-3 Correctly Aligned Waveform ..................................................................78
Figure 7-1 CN5 DC Input (View from rear of MX800) ..........................................103
Figure 7-2MX800 Setup in system rack...................................................................113
Figure 9-1 Receiver Component Overlay ...............................................................132
Figure 9-2 Exciter Component Overlay .................................................................133
Figure 9-5 Micro Controller Component Overlay (Rev P4) ..................................135
Figure 9-6 Tx and Rx VCO Component Overlay Bands A to Q3 ...........................136
Figure 9-7 Tx and Rx VCO Component Overlay Bands R to X..............................137
Figure 9-8 HP Rx VCO Component Overlay Bands A to Q ...................................138