Spectra Engineering MX800 - 3.17.12 T19;T26 Jumper Settings; Factory Default Jumper Settings

MX800 Transceiver Technical Manual
© SPECTRA ENGINEERING 2006 Revision 4.2.3
60
3.17.12 T19/T26 Jumper Settings
Table 3-11 T19/26 Factory Default Jumper Setting.
JMP
Number
Jumper description
Default Jumper Position
For T19/T26
JMP1 Decoder select 2-3
JMP2 M1 Source jumper N/F (Unlinked)
JMP3 M2 Source jumper N/F (Unlinked)
JMP4 E2 Source jumper N/F (Unlinked)
JMP5 E1 Source jumper N/F (Unlinked)
JMP6 RX Line compensation
IN/OUT
1-2
JMP7 RX Low pass filter IN/OUT 2-3
JMP8 RX Notch filter IN/OUT 1-2
JMP9 TX Notch filter IN/OUT 1-2
JMP10 2W/4W Selection 1-2 (4Wire mode)
JMP11 2W/4W Selection 1-2 (4Wire mode)
JMP12 2W/4W Selection 1-2 (4Wire mode)
JMP13 AGC IN/OUT 2-3
JMP14 High Pass Filter IN/OUT 2-3
JMP15 2W/4W Selection 1-2 (4Wire mode)
JMP16 2W Isolation Balance N/F (Unlinked)
JMP17 2W Isolation Balance N/F (Unlinked)
JMP18 2W Isolation Balance N/F (Unlinked)
JMP19 2W Isolation Balance N/F (Unlinked)
JMP20 Tone Generation path 1-2
JMP21 CNVSS Connected (CNVSS)
JMP22 2W/4W Selection 1-2 (4Wire mode)
JMP23 2W/4W Selection 1-2 (4Wire mode)
JMP24 4W Selection Linked
JMP25 4W Selection Linked
JMP26 RX DISC Audio Break Point 1-2
JMP27 TX Audio Break Point Connected
JMP28 AGC Ratio NF (Unlinked)
JMP29 RS232 Swap
JMP30 RS232 Swap
JMP31 D-A Section path RX/TX N/F (Unlinked)