SpectraLink 8440 - Page 154

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 154
Alert
DND
PIN, on successful entry call is answered.
Phone automatically locks on end of call.
appropriate can begin right away. Phone
remains locked.
Incoming IM
IM alert screen with first IM message
contents. User presses green key and is
prompted for user PIN, on successful entry
IM session is on hold. User presses resume
and IM session proceeds. Phone
automatically locks on end of call.
No IM alert screen displayed. Phone sends a
“486” response which means “The user was
contacted but is currently not willing or able to
take the call.”
The first IM message is added to the
conversation list and the missed message count
is incremented so the user can see they missed
a message.
Phone remains locked.
Table 8-43: Phone Lock Parameters
Parameter
Permitted Values
Default
phoneLock.authorized.x.description
The name or description of an authorized number
phoneLock.authorized.x.value
The number or address for an authorized call
recipient.
String
string
Null
Null
The numbers configured by these parameters appear on the Authorized Call menu when the New Call softkey is
pressed while the phone is locked.
Up to five (x=1 to 5) authorized contacts can be configured. Each contact requires a description that displays on
the screen, and a phone number or address value for the handset to dial.
These calls will only go through if the phone is registered and the numbers are recognized by the
call server.
Additional numbers configured in the dialplan may also appear on the Authorized Call menu. See Emergency Dial
via Authorized Call menu for additional information.
phoneLock.browserEnabled
0 or 1
0
If 0, the browser or browser is not displayed while the handset is locked and the handset cannot receive any
updates from a browser application. If 1, the browser is displayed while the handset is locked.
phoneLock.dndWhenLocked
0 or 1
0
If 0, the handset can receive calls while it is locked. If 1, the handset enters Do-Not-Disturb mode while it is locked.
The user can enable DND even if this parameter is set to 0 which will cause the handset to demonstrate the
behavior described in the above table until the user disables DND.
phoneLock.enabled
1
0 or 1
0
If 0, the handset lock feature is disabled. If 1, the handset lock feature is enabled. Note: To ‘unlock’ the handset
remotely (in conjunction with deleting/modifying the overrides files), disable and re-enable this parameter.
phoneLock.idleTimeout
0 to 65535
0
The amount of time (in seconds) the handset can be idle before it automatically locks. If 0, automatic locking is
disabled.
phoneLock.lockState
0 or 1
0
The value for this parameter indicates whether the handset is locked or unlocked and changes each time you lock
or unlock the handset. If 0, the handset is unlocked. If 1, the handset is locked. Note that the handset stores and
uploads the value each time it changes via the MAC-phone.cfg. You can set this parameter remotely using the
Web Configuration Utility.