SpectraLink 8440 - Network Configuration Menu

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 31
Admin: Changing the default administrator password
Spectralink recommends that you change the default administrative password. See
Passwords – User and Administrator.
You have the option of modifying the handset network configuration parameters in the following
menus and sub-menus:
 Main Menu
 Provisioning Server Menu
 Network Interfaces Menu (Ethernet Menu)
 TLS Menu
 Syslog Menu
Use the softkeys, the arrow keys, and the Select and Delete keys to make changes.
Certain parameters are read-only due to the value of other parameters. For example, if the
DHCP client parameter is enabled, the Phone IP Address and Subnet Mask parameters are
grayed out or not visible since the DHCP server automatically supplies these parameters and
the statically assigned IP address and subnet mask will never be used in this configuration.
Settings: Resetting network configurations
The basic network configuration referred to in the subsequent sections can be reset
to factory default settings using the handset’s main menu: Select Settings>
Advanced Settings> [enter password]> Administration Settings> Reset to
Defaults> Reset Device Settings. Or use a multiple key combination, as
described in Multiple Key Combinations.
Network configuration menu
You can modify the following configuration parameters from the setup menu while the handset
boots, or from the Administrative Settings menu from a handset running Spectralink Software:
Name
Possible Values
Provisioning server menu
See Provisioning Server Menu.
Network interfaces menu or Ethernet menu
See Network Interfaces Menu (Ethernet Menu).
SNTP address
Dotted-decimal IP address OR Domain name string
The Simple Network Time Protocol (SNTP) server the handset obtains the current time from.
GMT offset
-13 through +12
The offset of the local time zone from Greenwich Mean Time (GMT) in half hour increments.