SpectraLink 8440 - User Preferences Parameters

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 80
Parameter
Permitted Values
Default
tcpIpApp.sntp.daylightSavings.stop.date
1 to 31
1
The stop date for daylight savings time. If fixedDayEnable is set to 1, the value of this parameter is the day of
the month to stop DST. If fixedDayEnable is set to 0, this value specifies the occurrence of dayOfWeek when
DST should stop. Set 1 for the first occurrence in the month, set 8 for the second occurrence, 15 for the third
occurrence, or 22 for the fourth occurrence. For example, if set to 22, DST stops on the fourth dayOfWeek of the
month.
tcpIpApp.sntp.daylightSavings.stop.dayOfWeek
1 to 7
1
The day of the week to stop DST. 1=Sunday, 2=Monday, … 7=Saturday. Note: this parameter is not used if
fixedDayEnable is set to 1.
tcpIpApp.sntp.daylightSavings.stop.dayOfWeek.lastInMonth
0 or 1
0
If 1, DST stops on the last dayOfWeek of the month and the stop.date is ignored. Note: this parameter is not
used if fixedDayEnable is set to 1.
tcpIpApp.sntp.daylightSavings.stop.month
1 to 12
11
The month to stop DST. 1=January, 2=February… 12=December.
tcpIpApp.sntp.daylightSavings.stop.time
0 to 23
2
The time of day to stop DST – in 24 hour clock format. 0= 12am, 1= 1am,… 12= 12pm, 13= 1pm, … 23= 11pm.
tcpIpApp.sntp.gmtOffset
positive or negative
integer
0
The offset in seconds of the local time zone from GMT.3600 seconds = 1 hour, -3600 seconds = -1 hour.
tcpIpApp.sntp.gmtOffset.overrideDHCP
0 or 1
0
If 0, the DHCP values for the GMT offset will be used. If 1, the SNTP values for the GMT offset will be used.
tcpIpApp.sntp.resyncPeriod
positive integer
86400
The period of time (in seconds) that passes before the handset resynchronizes with the SNTP server. Note: 86400
seconds is 24 hours.
User Preferences Parameters
Options on various user menus can be pre-configured by the administrator.
Table 7-13: User Preferences Parameters
Parameter
Permitted Values
Default
up.backlight.idleIntensity
0, 1, 2, or 3
0
The brightness of the LCD backlight when the handset is idle. 0 – off, 1 – low, 2 – medium, 3 – high. Note: If this is
higher than the active backlight brightness (onIntensity), the active backlight brightness is used. When the
phone is in the charger, this parameter does not take effect, the backlight is always on.
up.backlight.onIntensity
0, 1, 2, or 3
3
The brightness of the LCD backlight when the handset is active (in use). 0: off, 1 – low, 2 – medium, 3 – high
up.backlight.timeout
5 to 60
10
The number of seconds to wait before the backlight dims from the active intensity to the idle intensity.