SpectraLink 8440 - Keypad Lock

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 66
Parameter
Permitted Values
Default
divert.x.autoOnSpecificCaller
2
0 or 1
1
If 0, the Auto Divert feature of the contact directory is disabled for registration x. If 1, calls on registration x may be
diverted using Auto Divert, you may specify to divert individual calls or divert all calls.
divert.busy.x.enabled
2
divert.busy.x.contact
1
0 or 1
contact address
1
Null
Divert incoming calls that reach a busy signal. If enabled is set to 1, calls will be diverted when registration x is
busy. Calls will be sent to the busy contact’s address if it is specified; otherwise calls will be sent to the default
contact specified by divert.x.contact. If enabled is set to 0, calls will not be diverted if the line is busy.
divert.dnd.x.enabled
2
divert.dnd.x.contact
1
0 or 1
contact address
0
Null
Divert calls when Do Not Disturb is enabled. If enabled is set to 1, calls will be diverted when DND is enabled on
registration x. Calls will be sent to the DND contact’s address if it is specified; otherwise calls will be sent to the
default contact specified by divert.x.contact.
divert.fwd.x.enabled
2
0 or 1
1
If 0, the user cannot enable universal call forwarding (automatic forwarding for all calls on registration x). If 1, a
Forward softkey will display on the flyout menu when you press the Features softkey.
divert.noanswer.x.enabled
2
divert.noanswer.x.contact
1
divert.noanswer.x.timeout
1
0 or 1
contact address
positive integer
1
Null
55
If no-answer call diversion is enabled, calls that are not answered after the number of seconds specified by
timeout will be sent to the no-answer contact. If the no-answer contact is set to Null, the call will be sent to the
default contact specified by divert.x.contact. If enabled is set to 0, calls will not be diverted if they are not
answered.
1
Change causes handset to restart or reboot.
2
Change causes handset to restart or reboot. If server-based call forwarding is enabled, this parameter is disabled.
Keypad Lock
Keypad Lock is enabled by default. This feature locks the keypad to prevent inadvertent dialing
while the phone is idle and/or while in a call. The feature adds a Keypad Lock and/or an In-call
Keypad Lock option on the Features softkey menu. Once the handset is locked for idle, an
Unlock softkey appears. When pressed it will unlock the keypad. No password is required. The
in-call keypad lock will expire when the phone call is ended.
If your deployment requires additional handset security, please see the Phone Lock section.
Table 7-3: Keypad Lock
Parameter
Permitted Values
Default
keypadLock.enabled
1
0 or 1
0
If 0, the keypad lock feature is disabled. If 1, the feature is enabled.
keypadLock.idleTimeout
1
0 to 65535
0
The maximum time (in seconds) the handset can be idle before the keypad will lock.