SpectraLink 8440 - Call Park and Retrieve

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 92
group call pick-up using a particular star-code sequence, others implement the feature using
network signaling.
The Spectralink 84-Series handsets can bypass some SIP server requirements and implement
various call handling features using Enhanced Feature Keys (EFK) instead. Please refer to the
EFK section for more information.
Call Park and Retrieve
You can park an active call and retrieve parked calls from any handset. Whereas call hold
keeps the held call on the same line, call park moves the call to a separate address where the
call can be retrieved by any handset.
Table 8-7: Configuring Call Park and Retrieve
Parameter
Permitted Values
Default
feature.callPark.enabled
1
0 or 1
0
If 0, the call park and call retrieve features are disabled. If 1, the features are enabled.
1
Change causes handset to restart or reboot.
Call Waiting Alerts
By default, the handset will alert you to incoming calls while you are in an active call.
Parameter
Permitted Values
Default
call.callWaiting.enable
0 or 1
1
If 1, the handset alerts you to an incoming call while you are in an active call. If 0, you are not alerted to incoming
calls while in an active call and the incoming call is treated as if you did not answer it. If 1, and you end the active
call during a second incoming call, you are alerted to the second incoming call.
call.callWaiting.ring
1
beep, ring, silent
beep
Specifies the ringtone of incoming calls when another call is active. If set to Null, the default value is beep.
1
Change causes handset to restart or reboot.
Calling Party Identification
By default, the handset displays the identity of incoming callers if available to the handset
through the network signal. If the caller is in the contact directory, you can choose to display that
name instead. Note that the handset cannot match the identity of calling parties to entries in the
Corporate Directory.
Table 8-8: Configuring Calling Party Identification
Parameter
Permitted Values
Default
up.useDirectoryNames
1
0 or 1
1
If 0, names provided through network signaling are used for caller ID. If 1, the name field in the local contact
directory will be used as the caller ID for incoming calls from contacts in the local directory. Note: Outgoing calls and
corporate directory entries are not matched.
1
Change causes handset to restart or reboot.