SpectraLink 8440 - Synchronizing with SNTP

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 79
Synchronizing with SNTP
The following table describes the Simple Network Time Protocol (SNTP) parameters used to set
up time synchronization and daylight savings time. The default values will enable and configure
daylights savings time (DST) for North America.
Daylight savings time defaults:
 Do not use fixed day, use first or last day of week in the month.
 Start DST on the second Sunday in March at 2am.
 Stop DST on the first Sunday in November at 2am.
Table 7-12: Simple Network Time Protocol (SNTP) Parameters
Parameter
Permitted Values
Default
tcpIpApp.sntp.address
Valid hostname or IP
address
Null
The address of the SNTP server.
tcpIpApp.sntp.address.overrideDHCP
0 or 1
0
If 0, the DHCP values for the SNTP server address will be used. If 1, the SNTP parameters will overrule the DHCP
values.
tcpIpApp.sntp.daylightSavings.enable
0 or 1
1
If 0, daylight savings time rules are not applied to the displayed time. If 1, the daylight savings rules apply.
tcpIpApp.sntp.daylightSavings.fixedDayEnable
0 or 1
0
If 0, month, date, and dayOfWeek are used in the DST calculation. If 1, only month and date are used.
tcpIpApp.sntp.daylightSavings.start.date
1 to 31
8
The start date for daylight savings time. If fixedDayEnable is set to 1, the value of this parameter is the day of
the month to start DST. If fixedDayEnable is set to 0, this value specifies the occurrence of dayOfWeek when
DST should start. Set 1 for the first occurrence in the month, set 8 for the second occurrence, 15 for the third
occurrence, or 22 for the fourth occurrence. For example, if set to 15, DST starts on the third dayOfWeek of the
month.
tcpIpApp.sntp.daylightSavings.start.dayOfWeek
1 to 7
1
The day of the week to start DST. 1=Sunday, 2=Monday, … 7=Saturday. Note: this parameter is not used if
fixedDayEnable is set to 1.
tcpIpApp.sntp.daylightSavings.start.dayOfWeek.lastInMonth
0 or 1
0
If 1, DST starts on the last dayOfWeek of the month and the start.date is ignored. Note: this parameter is not
used if fixedDayEnable is set to 1.
tcpIpApp.sntp.daylightSavings.start.month
1 to 12
3 (March)
The month to start DST. 1=January, 2=February… 12=December.
tcpIpApp.sntp.daylightSavings.start.time
0 to 23
2
The time of day to start DST – in 24 hour clock format. 0= 12am, 1= 1am,… 12= 12pm, 13= 1pm, … 23= 11pm.