SpectraLink 8440 - Local Digit Map

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 243
Summary
Parameter
Used to:
call.shared.disableDivert
Specify whether call diversion should be disabled by default on all shared lines
reg.x.type
Specify the per-registration line type (private or shared)
reg.x.thirdPartyName
Specify the shared line third-party name.
divert.x.sharedDisabled
Specify whether call diversion should be disabled on a specific shared line
(overrules default)
Table 11-5: Enabling Bridged Line Appearance
Parameter
Permitted Values
Default
call.shared.disableDivert
1
0 or 1
1
If set to 1, the diversion feature for shared lines is disabled. Note: This feature is disabled on most call servers.
reg.x.type
private or shared
private
If set to private, use standard call signaling. If set to shared, augment call signaling with call state subscriptions and
notifications and use access control for outgoing calls.
reg.x.thirdPartyName
string address
Null
This field must match the reg.x.address value of the registration which makes up the part of a bridged line
appearance (BLA). It must be Null in all other cases.
divert.x.sharedDisabled
1
0 or 1
1
If 0, call diversion features can be used on shared lines. If 1, call diversion features are disabled on shared lines.
1
Change causes handset to restart or reboot.
Local Digit Map
The handset has a local digit map feature that, when configured, will automatically call a dialed
number, eliminating the need to press the Dial or Send softkey to place outgoing calls. Note
that digit maps do not apply to on-hook dialing.
Digit maps are defined by a single string or a list of strings. If a number you dial matches any
string of a digit map, the call is automatically placed. If a number you dial matches no string—an
impossible match— you can specify the handset’s behavior. If a number ends with #, you can
specify the handset’s behavior, called trailing # behavior. You can also specify the digit map
timeout, the period of time after you dial a number that the handset will wait before the call will
be placed. The configuration syntax of the digit map is based on recommendations in section
2.1.5 of RFC 3435.
Summary
Parameter
Used to:
dialplan.applyTo*
Apply a dial plan to dialing scenarios
dialplan.digitmap
Specify the digit map to use for the dial plan
dialplan.digitmap.timeOut
Specify the timeout for each segment of the digit map